Rockwell Automation 2705 RediPanel Push Button Module User Manual
Page 85
LED Upgrade Kit
Appendix C
800A Switch Replacement Kit
C–2
1. Place the Push Button Module on a flat surface and locate the 4 screws
connecting the push button faceplate to the sheet metal housing.
Screws
2. Remove the screws and carefully slide the faceplate out of the housing.
Note: You will be able to slide the faceplate out approximately
1 inch (25 mm).
3. Unplug the ribbon cable(s) on the faceplate from the push button printed
circuit (PC)board. Note: 8 and 16 Push Button Modules have 1
ribbon cable and 32 Push Button Modules have 2 ribbon cables.
ЙЙЙ
ЙЙЙ
ЙЙ
ЙЙ
ЙЙЙ
ЙЙЙ
Ribbon Cables
Ribbon Cable
32 Button Module
8 or 16 Button Module
4. A 2-wire assembly is also connected to the PC board. Disconnect the
connector plug for this 2 wire assembly.
5. Select the correct template for the Push Button Module (8, 16, or 32
button) you are modifying. Place the Push Button Module face down on
the template.