Rockwell Automation 2705 RediPanel Push Button Module - Manual (Page 93)

A–B
G Appendix
G–1
Installing/Replacing Push Buttons
This appendix shows how to install or replace push buttons in RediPANEL
modules.
!
ATTENTION: To avoid electrical shock or unintended operation
of the equipment, disconnect power before servicing.
1. Open enclosure by loosening the screws on the back of
RediPANEL module. Guide the modules back door open.
2. Disconnect RediPANEL wiring from the push button you want to
replace.
3. Remove the push button from the enclosure.
4. Mount the replacement push button in the enclosure.
5. Attach RediPANEL wiring to the replacement push button. See
Push Button and Selector Switch Connection Examples on next page.
6. Carefully guide the modules back door closed. Be sure that the
wiring is not pinched between the side plate and the chassis.
Tighten the screws on the back of the RediPANEL enclosure.
Figure G.1
Replacing 800T/H Push Buttons
89-344-3
Installing or Replacing
800T/H Push Buttons