Rockwell Automation T8160 Trusted TMR Interface - Manual (Page 14)

Trusted TM TMR Module T8160
Issue 13 May 13 PD-T8160 14
3.3. Isolation
All signals exchanged between fault containment regions are protected to prevent the propagation of
faults between independently powered regions.
The processor and front-panel interface fault containment regions provide isolation for the 24Vdc
power feed in addition to the POWER WARNING signal.
3.4. I/O Modules Supported
The T8160 interface provides the following support for the Regent+Plus I/O modules. The equivalent
Regent I/O modules are also supported since their I/O safetybus interface is identical.
Module Single module Dual set Triple set
3401/7401 Yes Yes
3402/7402 Yes Yes
3404/7404 Yes Yes
3408/7408 No support
3411/7411 Yes
3411F/7411F Yes Yes
3418F/7418F Yes
3419/7419 Yes
3420A/7420A Yes
3420AF/7420AF Yes – see below
3431/7431
Yes
3431A/431A Yes
3432/7432 Yes – see below
3441A/7441A Yes Yes
3444/7444 Yes Yes
3446H/7446H Yes Yes
3446L/7446L Yes Yes
3454/7454 No support
3461A/7461A Yes Yes
3462A/7462A Yes Yes
3464/7464 Yes Yes
3468A/7468A No support
3470A/7470A Yes
3478/7480 Yes
3481/7481 Yes Yes
3481A/7481A Yes Yes
3484/7484 Yes Yes
3485/485 Yes Yes
3488/7488 Yes Yes
3488A/7488A Yes Yes
3491/7491 Yes
The 3420AF/420AF and 3432/7432 are not supported in Toolset / processor firmware TÜV 3.5.1. They
have since been added. Contact [email protected] for details if these modules are required.