Great Plains NP3000A Operator Manual - Manual (Page 173)

Great Plains Manufacturing, Inc. Table of Contents Index Appendix D - Accessory Installation 169
2014-04-22 Table of Contents Index 407-613M
Connect Coulter Tubing
Refer to Figure 96
44. At the left end of the front boom, remove one cap
and gasket from the boom clamp:
832-042C NOZZLE SHUT OFF CAP W/ GASKET
CP18999-EPR ORIFICE SEAT STYLE GASKET
If a nozzle was removed at step 18 on page 166,
relocate the shut-off cap
and gasket to the
open rear row boom clamp.
45. Select one new or saved:
CP18999-EPR ORIFICE SEAT STYLE GASKET
Install an orifice plate inside the gasket .
46. At the front left boom clamp, install one set of:
New or saved nozzle set:
407-373S NOZZLE ASSEMBLY - 3/8 HOSE
which includes:
830-071C AD 1/4MNPT X 3/8HB POLYPROP
832-051C NOZZLE CAP QUICK X 90X1/4 FNPT
New half rate variable flow nozzle:
829-143C NOZZLE HI-VERIFLOW1 (GRN/YEL)
or saved full rate nozzle:
829-144C NOZZLE VERIFLOW1 (BLU)
Refer to Figure 96 and Figure 97
47. Select one new or saved:
990-080R HOSE 3/8 ID 150PSI EPDM
and two:
800-390C CLAMP WRM DRV #6 SS (.38-.87)
Connect this hose from the nozzle to the coulter
applicator attachment
.
Refer to Figure 98
48. Select one set new or saved:
800-130C GREASE ZERK STRAIGHT 1/8-27NPT
800-158C FTG TUBE,CONNECTOR 1/8 FNPT
Install these at an available hole in the front left wing
grease bank.
49. Select the new or saved:
990-109R TUBE NYLON 1/4OD X 062WL
Connect this from the grease bank fitting to the
coulter pivot fitting (not shown). Secure with cable
ties between grease bank and coulter.
50. Pump grease until it emerges at the coulter pivot.
51. Continue at “Shift 2-Point Hitch” on page 172.
Figure 96
Fertilizer Nozzle Parts
34963
L38
L39
L37
L40
L36
L36
L37
L36 L37
L37
L38 L37
31
21
L39
Figure 97
Drop Line, Grease Connections
32028
70
44
12
L41
L40
L40
L41
44
12
Figure 98
Grease Bank Fittings
32081
16
42
70
42
16
70
16