Great Plains NP3000A Operator Manual - Manual (Page 47)

Great Plains Manufacturing, Inc. Table of Contents Index Preparation and Setup 43
2014-04-22 Table of Contents Index 407-613M
Leveling Implement
During initial setup and periodically throughout the
season, check that the implement runs level. When
applying fertilizer, the top of the main frame should be
parallel to the ground, and level left to right.
Set Application Depth
Before checking or correcting side-to-side or
front-to-back level, set the application depth (which is
controlled by tool bar height).
The Nutri-Pro ® Liquid Fertilizer is designed for
application at:
0 to 6in (0 to 15.3 cm)
For adjustment, see “Vantage I Coulter Adjustments”
on page 82.
To check level, lower the implement into the ground in
representative conditions.
2-Point Front-to-Back Level (Spacers)
The rear lift-assist assembly must be set to match the
gauge wheels and 2-point hitch in front. Lift-assist
lowered height is controlled by (provided) spacers on the
lift cylinder rods.
To set:
1. Lower implement until lift assist wheels are just off
the ground.
2. Raise implement until wheels touch ground just
firmly enough to resist spinning.
Refer to Figure 18
3.
Insert a combination of spacers to fill the space on
the rod between the cylinder end and clevis.
4. Raise and lower implement. Pull forward and check
coulter depth and front-to-back level. Adjust spacers
as required to achieve desired application depth.
Figure 17
2-Point Leveling
32002
U
D
B F
Figure 18
Lift Assist Lowered Height
31636
6
5
5
6