CANOGA PERKINS 3240S SNMP Managed Fiber Optic Multiplexer - Manual (Page 55)

3240S F I B E R O P T I C M U L T I P L E X E R
3240S Fiber Optic Multiplexer
4.8.4 SNMP & Access Host Table
This is a sub-menu which allows the operator to set up to four hosts/managers and the community strings for SNMP. To
access this sub-menu select '5' then 'Enter' from the SNMP Agent Configuration Screen. The Host & Community Tables
Screen will appear as referenced in Figure 4-8.
Figure 4-8
Host & Community Tables Screen
4.8.4.1 Access Host Table
It is possible to enter up to four Managing Hosts in the table. Only the hosts in this table will be able to communicate with the
Management Module SNMP Agent. Each host has an IP address, an access level which tells the agent if it must send traps
to the host, and if the host can read only, or read and write to the Management Information Base (MIB). Traps, or the "Trap
Community," represents the community associated with the Trap Protocol Data Unit (PDU). To set the Access Host Table
select '1,' then 'Enter' from the SNMP Agent Configuration sub-menu. The Host & Community Tables Screen appears. Enter
the IP Address of the accessing host, the access level, and the trap community name when prompted. Reference Figure 4-9.
As stated in the latter paragraph, only four managing hosts may be entered in the Access Host Table. To delete a host, select
'2,' then 'Enter' from the SNMP Agent Configuration sub-menu, then enter the IP address of Accessing Host to be deleted.
Reference Figure 4-10.
4-13