360 Systems DigiCart/II Plus - Manual (Page 20)

8 • Getting Started DigiCart/II Plus Owner's Manual
Press and hold the SEC button to insert the Secondary cue.
Press the STOP button to end recording.
Making A Digital Recording
Select the digital input you would like to record.
If desired, select Dolby AC-2 data compression for 48K digital inputs. If you do not wish to
compress a 48K digital input, select any format other than AC-2. (44.1K and 32K digital input
signals are never compressed.)
Select a record trigger threshold.
Select the appropriate digital audio input type in the set-up menu.
Press the RECORD button and disk space will be allocated.
You will be instructed to press PLAY when you are ready to enter the record mode.
Press the PLAY button. Once the digital input signal is valid, DigiCart/II Plus will wait for the
audio level to cross the Trigger Threshold. Recording then starts, and will continue until the STOP
button is pressed, or the digital input signal stops or becomes invalid.
The recorded format of the resulting cut is identical to one made from an analog source.
NOTE: DigiCart/II Plus will drop out of the record-ready mode while waiting for a trigger if the
digital input becomes invalid.
Checking Available Drive Space
Press and hold the STOP button.
Playing A Single Cut
Rotate the SELECT control to choose a cut name.
Press the PLAY button.
Playing Multiple Cuts – Follow-On Play
While playing, select next cut. You can change layers to select other drives or directories.
Press the PLAY button. The PLAY button will flash to indicate that at least 1 cut is waiting to play.
Repeat as needed.
Press the VIEW LIST button, use the SELECT control to see items following current cut.
To stop playback after current cuts ends, press the STOP button once.
To stop playback immediately, press the STOP button twice.