360 Systems DigiCart/II Plus - Manual (Page 92)

80 • File Transfer Network DigiCart/II Plus Owner's Manual
1. On the source machine, select the cut to be transferred.
2. Press the D-NET XFER button and the display will show:
TRANSFER CUT
PRESS ENTER/CANCEL
3. If you choose to transfer the directory in which the cut resides, rotate the
SELECT control clockwise and the display will show:
TRANSFER DIRECTORY
PRESS ENTER/CANCEL
4. If you choose to transfer the drive in which the directory resides, rotate
the SELECT control clockwise and the display will show:
TRANSFER DRIVE
PRESS ENTER/CANCEL
5. Press the ENTER button to confirm your choice. If no destination has
been previously assigned and used, the display will show:
DESTINATION NAME
(NONE SPECIFED)
6. To assign a new destination name, press the ENTER button again. (See
RECEIVER NAMES AND DESTINATION NAMES earlier in this
Chapter). The display will show:
▒
NEW DESTINATION NAME
7. Using the SELECT control and the Left and Right POSITION buttons,
enter the new destination name. When you have spelled out the new
destination name, press the Right POSITION ARROW button until the
cursor is to the right of the last character in the new destination name.
Press the ENTER button. The display will show:
DESTINATION NAME
(YOUR NEW DESTINATION
NAME)
8. Rotate the SELECT control clockwise. The display will show either:
DESTINATION LOCATION
(THE LOCATION OF THE CUT IN
THE SOURCE MACHINE)
OR