360 Systems DigiCart/II Plus - Manual (Page 21)

DigiCart/II Plus Owner's Manual Getting Started • 9
Pause
Used to temporarily interrupt recording or playback, or create Playlists. Note that Pause during Record
does not work when using digital input.
Using PAUSE during Play or Record
Press the PAUSE button to interrupt.
Press the PAUSE button again to resume.
Using PAUSE to create a Playlist — Quickstack, stack
Press the PAUSE button.
Select a cut.
Press the PLAY button to enter in list.
Select the next cut and press the PLAY button, repeating for each cut to be entered in the Playlist.
Press the PAUSE button to Play the list (a Quickstack) or press the ENTER button to save the list
as a stack.
Looping
Causes the current cut to play continuously from HEAD to TAIL.
Play the cut you want to loop.
Press the LOOP button to activate.
Press LOOP button again to discontinue or press STOP once to stop at the end of the current loop.
Press STOP twice to stop immediately.
Select cut for cue selection.
Press and hold the SEC button.
Press the CANCEL button.
Secondary Cues
Activating a Secondary cue, closes one pair of "Form C" relay contacts. This contact closure can
be used to connect, disconnect or redirect a circuit. Cues may be placed or moved during PLAY or
RECORD and HEAD or TAIL editing.
Play the selected cut.
Press the SEC button where relay should actuate.
Hold for desired duration. The contacts will remain closed for the duration of the cue.
Programming a cue will remove any previously programmed cue.
NOTE: Only one cue can be programmed per cut.
Deleting A Secondary cue
Select cut for cue deletion.
While pressing and holding the SEC button, press the CANCEL button.