360 Systems DigiCart/II Plus - Manual (Page 23)

DigiCart/II Plus Owner's Manual Getting Started • 11
Utility Menu Operations
Utility Menu features are:
CHANGE NAME ERASE COPY ORIGINAL
COPY EDITED RENUMBER DISK ASSIGN PRESET
CLEAR PRESET FILE TRANSFER FORMAT DISK
UPDATE DIRECTORIES PARTITION DRIVE
GENERAL PROCEDURE:
5. Select the drive, directory, cut or stack you wish to work upon.
6. Press the UTILITY MENU button to enter the menu.
7. Use the SELECT control to view menu options.
8. Follow the screen prompt to activate an option.
9. Press the CANCEL, STOP or PLAY button to exit the Utility Menu.
See Utility Menu Operations on page 40 for detailed procedures.
Edit Menu Operations
Edit Menu features are:
HEAD (TRIM) FADE IN OUTPUT GAIN
TAIL (TRIM) FADE OUT PRE-ROLL
GENERAL PROCEDURE:
1. Select the drive, directory, cut or stack you wish to work upon.
2. Press the EDIT MENU button to enter the menu.
3. Use the SELECT control to view menu options.
4. Follow the screen prompt to activate an option.
5. Press the CANCEL, STOP or PLAY button to exit the Edit Menu.
Time display is HH:MM:SS:FF.BB: Hours, Minutes, Seconds, Frames and SMPTE Bits. The
selected unit shows in the display in brackets, for example <F> for Frames.
Output Gain is adjustable in decibels and tenths of a decibel.
Use the Left and Right POSITION buttons to select units.
Minimum cut length is about two seconds. Head and Tail times will be limited to maintain this
minimum length.
See Edit Menu Operations on page 51 for detailed procedures.