360 Systems DigiCart/II Plus - Manual (Page 55)

DigiCart/II Plus Owner's Manual Operating Instructions • 43
REPLACING
TARGET ID CUT NAME
When the copy procedure is completed, DigiCart/II Plus displays:
X.XXXX NEW NAME
HH:MM:SS 48K AC-2
8b. To copy to an unused Index number: Rotate the SELECT control to lock out access
to existing cuts. The display will Show:
X.XXXX
SELECT NEW INDEX #
Only unoccupied IDs will be shown.
9. Press ENTER to copy. The display will briefly flash:
COPYING
TARGET ID NEW NAME
When the copy procedure is completed, DigiCart/II Plus displays:
X.XXXX NEW NAME
HH:MM:SS 48K AC-2
C OPYING A S TACK
DigiCart/II Plus handles stacks in the same manner as cuts. Use the same COPY ORIGINAL
procedures as for cuts. Original stacks may only be copied to other numbers in the Stack Directory.
NOTE: While stacks can be copied from one drive to another, they still reference the index
numbers of the cuts they contain. Therefore, if you copy a stack to a Zip cartridge, it will play
correctly only in the unit in which it was made or in another unit that contains the same material in
the same index locations. Copying the stack to a cut on the cartridge avoids this problem. See
“Copy Edited - Copying a stack.”
C OPYING A D IRECTORY
Duplicates cuts in a source directory to any destination directory.
1. Select a directory as the source. You MUST be in the directory level and not the
Cut level to do this.