360 Systems DigiCart/II Plus - Manual (Page 59)

DigiCart/II Plus Owner's Manual Operating Instructions • 47
3. Press (turn ON) the RC-205's Scroll Lock.
4. Use the SELECT control to choose the RC-205 alphabet or compound-alpha key
(i.e.: SHIFT+A, CTRL+B, ALT+X etc.) , or RC-220's white Hot Key number for
the PRESET.
5. Press the ENTER button. The selected item is now assigned to the key. Press the
key to play it.
A SSIGNING A S INGLE P RESET U SING T HE RC-210/RC-220 (M ETHOD 2):
1. Press ASSIGN PRESET. The display will show:
X.XXXX CUT NAME
SELECT PRESET
2. Use the Left and Right POSITION buttons and select buttons or FIND operation
to choose a cut or Linear Stack.
3. Press the PRESET key to be assigned.
4. The bottom line of the display will briefly flash:
PRESET XX ID NUMBER
5. Repeat as needed for other assignments.
6. Press the CANCEL button to exit. The selected item is now assigned. Press the
key to play it.
A SSIGNING M ULTIPLE P RESETS O N T HE RC-205, O R RC-210/RC-220
1. Use the Left and Right POSITION buttons and SELECT control to determine the
first cut or Linear Stack you wish to assign.
2. Press the Left POSITION button to go to the directory level.
3. Press the UTILITY MENU button and select ASSIGN PRESET.
4. Press the ENTER button.
5. Turn ON the RC-205's Scroll Lock. The display will show:
PRESET 0 A
UNASSIGNED
6. Use the SELECT control to choose the Hot Key number or alphabet letter for the
PRESET where the assignment is to begin.
7. Press the ENTER button.
Assignment will continue until all sources are assigned or all available destinations are filled.
Assignment continues to the end of your sort sequence and does not wrap around to continue at the
beginning.
The following table shows the general relationship of index and preset addresses for mass
assignment of presets beginning at ID 000.