360 Systems DigiCart/II Plus - Manual (Page 40)

28 • Operating Instructions DigiCart/II Plus Owner's Manual
Cues
A cue pointer is used to control a relay circuit present on the rear panel CUE OUTPUTS connector
on a DigiCart/II Plus. The relay provides "Form C" contacts allowing you to connect or disconnect
a circuit. You may also redirect a signal from one destination to another, or select between two
available signals when the cue occurs. The Secondary cue output appears on the Remote control
connector.
Secondary cues are not audio tones and do not require Disk space or an extra track. DigiCart/II
Plus remembers when and how long you press and release the SEC button and places pointers in
the audio file at those times. An LED lights to indicate the presence and duration of the cue.
Secondary Cues
Creating A Secondary Cue:
1. During play or record, press the SEC button at the location where you want the
Secondary relay to actuate.
The relay will remain active until the button is released.
NOTE: Cues may also be placed during HEAD and TAIL editing operations.
Changing A Secondary Cue:
2. To relocate a Secondary cue in an audio file, press the PLAY button to initiate
playback.
3. Press and release the SEC button at the point where you want to place the new
Secondary.
DigiCart/II Plus will automatically erase the old Secondary and place the new Secondary where you
press SEC.
Deleting/Erasing A Secondary Cue
Select the cut you want to edit. While pressing and holding the SEC button, press the CANCEL
button.
The display will show:
X.XXXX CUT NAME
DELETING SECONDARY
When the Secondary has been deleted, DigiCart/II Plus returns to Cut Select mode.