360 Systems DigiCart/II Plus - Manual (Page 48)

36 • Operating Instructions DigiCart/II Plus Owner's Manual
UP ARROW SELECT KNOB CW SELECT KNOB CW
DOWN ARROW SELECT KNOB CCW SELECT KNOB CCW
LEFT ARROW LEFT POSITION
ARROW LEFT POSITION ARROW
RIGHT ARROW RIGHT POSITION
ARROW RIGHT POSITION ARROW
ENTER / RETURN ENTER ENTER
ESCAPE CANCEL CANCEL
0 - 9 INDEX NUMBER
LOCATORS INDEX NUMBER LOCATORS
SCROLL LOCK PRESETS PRESETS
NOTES:
1. Not all "AT" keyboards will work with DigiCart/II Plus.
2. If you connect the keyboard (or another remote control) after power-up, press SEC
and the DNET XFER button together to re-initialize the system.
3. If the keyboard selection is incorrect, the function keys will not line up with their
assigned function.
Remote Control
Selects whether the rear panel Serial Port connector is active. When REMOTE control is set to
INACTIVE, DigiCart/II Plus will not respond to remote control serial interface commands. To
activate remote control, you must select an ADDRESS (1 - 32) to establish communication between
DigiCart/II Plus and a host computer/automation controller connected to the port. Addresses 1 to 4
correspond to the four machine control buttons on the 360 Systems RC-220 Remote control. The
RC-210 requires a setting of address 01.
It is recommended that Remote Control remain set to INACTIVE if not in use. If you intend to use
DigiCart/II Plus with an automation system that requires serial communication, consult with the vendor of
that system to determine the correct setting for this function. For more details on DigiCart/II Plus's remote
control capability, refer to CHAPTER TWO – pg. 19, Serial Control.
1. Press the SETUP MENU button and use the selection controls to choose and
confirm your selection:
REMOTE CONTROL
INACTIVE
OR
REMOTE CONTROL
ADDRESS XX
Cart Spindown (Time-Out)
Determines if the Cart Drive will remain active and on-line or "Time-out" after 30 minutes. When
set to ON, if the Drive is not accessed for 30 minutes it will spin down to save wear and prolong its
life span. A setting of OFF causes the drive to run continuously. We strongly recommend leaving
Cart Spindown ON.