360 Systems DigiCart/II Plus - Manual (Page 89)

DigiCart/II Plus Owner's Manual File Transfer Network • 77
A Receiver can be set up to accept ONLY those transfers addressed to its Mail
Box, thus enabling it to accept non-destructive transfers only.
You may also enter a specific destination location when making a D-NET transfer. This
method enables you to transfer files to the location that is most useful. Many DigiCart/II
Plus users have well structured name and location conventions that make this type of
transfer very convenient, because you can transfer a cut directly to its final destination
and be able to find it easily. Index numbers assigned to stacks or presets maintain those
associations. Thereby allowing playlists to be updated, or parts of a preset-driven set of
effects to be changed.
When no destination location is specified, D-NET will make the transfer to the same
location in the receiver as the file originated from in the source machine.
The 360 Systems Instant Replay can receive cuts in AC-2 format from your DigiCart/II
Plus. As the Instant Replay has only a single Directory, specific designation transfers
must be made to Disk 1, Directory 0. Mail Box transfers will be placed in the lowest
available, after the highest numbered existing cut.
NOTE: A transfer made to a specific location will replace any files at that
location.
To set the type of transfers your DigiCart/II Plus will accept:
1. Press the D-NET XFER button. (It will illuminate when pressed) Rotate
the SELECT control until the display shows either:
TRANSFERS TO ACCEPT
ALL
OR
TRANSFERS TO ACCEPT
MAIL BOX ONLY
2. If desired, use the Left and Right POSITION buttons select the alternate
menu item. Confirm your choice by pressing the ENTER button.
To make a transfer, refer to “Making A File Transfer” later in this Chapter.
File Receiver
Setting the File Receiver enables or disables file reception on your DigiCart/II Plus.
When set to ON your DigiCart/II Plus will receive file transfers. When set to OFF, the
machine will not receive file transfers.
NOTE: DigiCart/II Plus automatically disables Input Monitor when File Receive is on. It
is still indicated as ON in the Setup Menu and will automatically resume when File
Transfer is turned off. Input monitoring during Record Ready is unaffected.
To set the File Receiver on your DigiCart/II Plus:
1. Press the D-NET XFER button. Rotate the SELECT control and the
display will show either:
RECEIVER INPUT
ON