360 Systems DigiCart/II Plus - Manual (Page 29)

DigiCart/II Plus Owner's Manual Controls and I/O • 17
The PAUSE Button
(Illuminates when enabled)
Press the PAUSE button to:
Activate or release Pause mode in PLAY or RECORD. Note that Pause during
Record does not work when using digital input.
In Stop mode to build a playlist or stack.
The LOOP Button
(Illuminates when enabled)
Press the LOOP button to:
Activate Looping during PLAY. The current cut will continue to cycle until
LOOP is pressed again. The PLAY button will flash until the STOP button is
pressed once or LOOP is pressed again. The LOOP function cannot be activated
in STOP mode.
In Loop mode, pressing STOP twice will stop playback immediately.
The D-NET XFER Button
(Illuminates when enabled)
Press the DNET XFER button to:
Activate DNET transfer functions. DNET is used to transfer cuts, directories,
stacks or entire drives between two DigiCarts. Please refer to Chapter Six:
File Transfer Network.
The INPUT LEVEL Knobs
The INPUT LEVEL knobs adjust the record level for the left and right audio channels.
The Peak Level Meters
DigiCart/II Plus uses quasi-peak reading LED level meters for monitoring left and right channel
audio levels. These meters have been selected over standard VU meters for their advantages in
monitoring digital audio.