360 Systems DigiCart/II Plus - Manual (Page 96)

84 • File Transfer Network DigiCart/II Plus Owner's Manual
GOOD FILES: XX
BAD FILES: XX
This indicates the number of files received without errors and the number of files
discarded due to errors.
Errors in the receiver can be due to:
A faulty D-NET connection.
Excessive disk fragmentation causing space allocation time to exceed the
time allowed.
Hardware failure in the receiving unit.
Errors caused by the transmitting unit will usually be shown on the display of the
transmitting unit.
D-Net Implementation On Instant Replay And Shortcut
Please refer to your Instant Replay or Shortcut manuals for complete information on the
implementation of D-NET on these products.
Idle State D-Net Messages
LOCATION MESSAGE MEANING
SOURCE COULD NOT OPEN
FILE
FILE TO SEND COULD NOT BE
OPENED
SOURCE FILE IS EMPTY FILE TO SEND IS EMPTY
SOURCE NO FILES TO SEND DRIVE TO SEND IS EMPTY
SOURCE PART OF FILE
MISSING
FILE IS SHORTER THAN
EXPECTED
EITHER DISK ERROR ERROR READING / WRITING
THE FILE TO BE
SENT / RECEIVED
EITHER TOO MANY ERRORS 20 DISK OR FILE ERRORS
OCCURRED
EITHER CANCELED BY USER USER ABORTED TRANSFER BY
PRESSING CANCEL or STOP
RECEIVER TIMED OUT DATA WAS NOT RECEIVED FOR
10 SECONDS
RECEIVER MAIL BOX FULL INDEX 999 IN THE MAIL BOX IS
IN USE
RECEIVER OUT OF DISK SPACE DRIVE DOES NOT HAVE
ENOUGH SPACE TO SAVE THE
FILE
RECEIVER DATA OVERRUN DRIVE CANNOT ALLOCATE
SPACE IN TIME DUE TO
FRAGMENTATION