360 Systems DigiCart/II Plus - Manual (Page 78)

66 • Stack Mode DigiCart/II Plus Owner's Manual
5. The PLAY button will begin to blink, indicating that more than one item has been
selected for Follow-On Play. The time under the name shows total Quickstack
duration. To check the Quickstack's contents:
5a. Press the VIEW LIST button.
5b. Use the SELECT control to scan through the Quickstack.
(NOTE: The first cut will not read out as cut #1, only the cuts that follow will read in this step. In
fact, the second cut will read as cut #1 in the stack. Once the list has been saved, all will read
correctly.)
6. Press to release PAUSE (or press the MAKE PLAYLIST button) to play the
Quickstack. The PAUSE button will go dark and the Quickstack will play. The
top line of the display shows the last item in the stack, the bottom line presents the
current item and its timing information.
While playing, use the VIEW LIST button and SELECT control to see the remaining items in the
list. The number at the upper left shows how many items away the top line event is from the
selection currently playing.
NOTE: At any time during the running of a Quickstack, you may press the LOOP button. The
current selection will repeat until LOOP is pressed again.
To interrupt, press the STOP button. The current item will continue to completion. For immediate
cancellation, press STOP again.
Saving A Stack
After you have built a Quickstack you may examine it (VIEW LIST), Play it (release PAUSE) or
store it as a stack.
1. To save a Quickstack, press the ENTER button. The display will show either:
LINEAR
SELECT WITH ARROWS
OR
ROTATING
SELECT WITH ARROWS
2. If desired, press the Left or Right POSITION buttons to choose the alternate item.
3. Press the ENTER button to confirm the selection. DigiCart/II Plus will assign the
next available ID and name. The display will read:
X.SXXXL NEWSTK_XXX
FIRST CUT IN
THE NEW STACK
HH:MM:SS
Use CHANGE NAME in the UTILITY MENU to give the stack a new name.