360 Systems DigiCart/II Plus - Manual (Page 91)

DigiCart/II Plus Owner's Manual File Transfer Network • 79
implement a “Star” D-NET network to avoid the use of the Echo function. This is made
easier by the fact that the audio output through the BNC connectors on a DigiCart/II Plus
is compatible with standard 75
Ω video routers and distribution amplifiers.
Alternately, use the following procedure for recording the digital output of a DigiCart/II
Plus that has both file receiver and receiver echo enabled:
1. Press pause on the source DigiCart/II Plus.
2. Press play on the source DigiCart/II Plus.
3. Begin digital recording on the target machine.
4. Release pause on the source DigiCart/II Plus.
Selecting The I/O Connector
The Receiver Input menu item enables you to select either the BNC or XLR digital I/O
connectors for transmitting and receiving files.
To select the I/O connector on your DigiCart/II Plus:
1. Press the D-NET XFER button. Rotate the SELECT control until the
display shows either:
RECEIVER INPUT
BNC
OR
RECEIVER INPUT
XLR-3
2. If desired, use the LEFT and RIGHT POSITION buttons select the
alternate menu item. Confirm your choice by pressing the ENTER
button.
NOTE: A BNC Male/RCA Female adapter will allow you to connect to your DigiCart/II
Plus with a male RCA connector.
Making A File Transfer
To receive a transfer into your DigiCart/II Plus:
Must be connected to the source DigiCart/II Plus.
Must be turned on.
Must be enabled to receive file transfers.
Must not be playing or recording.
If your DigiCart/II Plus has a Receiver name programmed, the
transmission must be for that Name or a wildcard that matches it.
Before beginning, you must decide if you want to transfer a cut, a directory, or an entire
drive. However, if you have begun transfer setup, you may use the SELECT control to
choose a higher layer transfer without having to begin again. You could, for example,
begin the setup for transferring a single cut and choose instead to transfer the entire
directory or drive in which the cut resides.