360 Systems DigiCart/II Plus - Manual (Page 83)

DigiCart/II Plus Owner's Manual Stack Mode • 71
4. Use SELECT and POSITION Arrows to find the event you wish to APPEND.
5. Press the ENTER button to APPEND. DigiCart/II Plus returns to the Scan Mode.
6. Press the ENTER button to continue editing or press the CANCEL button to exit
the stack Edit Menu. The display prompts:
X.XXX (NEW NAME)
SAVE CHANGES? Y/N
The number at the upper left shows the new item's position in the stack.
7. Press ENTER to save or CANCEL to exit. DigiCart/II Plus returns you to the
Stack Directory.
Looping A Linear Stack
Using APPEND, select the stack itself as the Appended event. This tells DigiCart/II Plus to play
the stack again as the next event. In the Stack Directory, looped stacks may be recognized by a
stack time display that reads: 99:99:99.
Remove
Deletes the currently selected event from the stack. From the Scan Mode,
1. Press the ENTER button.
2. Use the SELECT control to choose REMOVE.
3. Press the ENTER button again. The display reads:
X.XXXX (EVENT)
REMOVE
4. Press the ENTER button to remove the selected event. DigiCart/II Plus returns to
the Scan Mode.
5. Press the ENTER button to continue editing or press the CANCEL button to exit
the stack Edit Menu. The display prompts:
X.XXXX (NAME)
SAVE CHANGES? Y/N
6. Press the ENTER button to save or the CANCEL button to exit. DigiCart/II Plus
returns you to the Stack Directory.
NOTE: If a cut required for a stack has been deleted, or resides on a drive not currently available
to DigiCart/II Plus, then " * " will be displayed next to the stack time when that stack is selected.
Use SCAN to determine which item is missing. The " * " will appear when the missing event is
selected. Remove the missing event or recreate it in its same ID. If the stack with the missing event
is part of other stacks, the warning " * " will appear on those too.