360 Systems DigiCart/II Plus - Manual (Page 39)

DigiCart/II Plus Owner's Manual Operating Instructions • 27
3. To continue Record, press the Pause button again. The button will go dark and
recording will resume.
NOTE: There’s no limit to the number of times the Pause button can be pressed during playback or
recording of a cut. However, pressing PAUSE during fade in will cause the fade in to start over
when the PAUSE button is released. Note that Pause during Record does not work when using
digital input.
Looping
Looping causes the currently selected cut to play continuously. The current HEAD and TAIL
pointers will always determine the loop point for that cut. (i.e.- The cut will play from HEAD to
TAIL continuously.) To activate looping, press the LOOP button while the cut is playing. The
LOOP button will illuminate. Once looping is on, that cut will play continuously until looping is
turned off by one of the methods listed below.
Looping can be used with Playlists. Looping can be turned on and off at any time without affecting
the Playlist. While one cut is looping, you may use the SELECT control and press the PLAY
button to add additional cuts to the Playlist. When you turn off looping, DigiCart/II Plus will
proceed with playback of the remaining cuts in the Playlist.
In the case of a Stack Mode Playlist, looping will operate without affecting the contents of the
stack. If looping is turned off by pressing the LOOP button, the stack will continue playing
normally until completed.
Turning Loop On
1. Press the LOOP button during play.
2. The LOOP button will illuminate and the currently selected cut will play
continuously until looping is turned off.
Also, the PLAY button will blink to show that looping is active.
Turning Loop Off
1. When the LOOP button is illuminated (indicating that LOOP is active), pressing
the LOOP button will turn looping off, but the currently looping cut or playlist will
play to completion.
2. If there are no additional cuts selected in the playlist, the PLAY button will go
solid, indicating that playback will stop at the end of the current cut. If other cuts
exist in the playlist, the PLAY button will continue to blink, indicating that
DigiCart/II Plus will continue playback of the remaining cuts in the playlist.
3. Loop may also be turned off by pressing the STOP button once. Pressing the
STOP button twice during Loop mode will immediately stop playback of the
current cut, and all other cuts in the playlist.