Renumber disk, Assign preset – 360 Systems DigiCart/II Plus User Manual

Page 58

Advertising
background image

46

Operating Instructions

DigiCart/II Plus Owner's Manual

Renumber Disk

Allows you to number disks for identification purposes. Press and hold the STOP button to view a
disk's number and name (if labeled). Once a disk has been assigned a number, it will retain that
number until this function is used to change it.

1. Press the ENTER button. The display will prompt:

0000

RENUMBER DISK

A cursor will blink on the first number.

2. Use the SELECT control and Left and Right POSITION buttons to choose a new

number.

3. Press the ENTER button to confirm your selection.

Assign Preset

Lets you assign a cut or Linear Stack to a single "Hot Key" on a DigiCart/II Plus Remote Control or
to the letter keys of an alphanumeric keyboard. When assigned, the selection will play immediately
with a single keystroke.

Cuts assigned to PRESETS may be Dolby AC-2 or linear format. The maximum
number of linear cuts is 16.

PRESETS must be cuts on a hard disk drive. (Not ID 0.XXXX or 6.XXXX)

PRESETS are subject to the currently selected RESTART MODE. (i.e.,
IMMEDIATE or ON COMPLETION).

Contents of a directory may be mass assigned to PRESETS by entering the
UTILITY MENU'S ASSIGN PRESET from the directory level.

PRESET 1 = 1 on the RC-210/220 or A on the alphanumeric keyboard.

PRESET 2 = 2 on the RC-210/220 or B on the alphanumeric keyboard, etc.

The alphanumeric keyboard's Scroll Lock must be ON for it to ASSIGN or PLAY
PRESETS. Scroll Lock may be ON or OFF to CLEAR PRESETS.

It is not necessary to clear a PRESET before reassigning it.

A

SSIGNING

A

S

INGLE

P

RESET

U

SING

T

HE

RC-205;

O

R

RC-210/220

(M

ETHOD

1):

1. Press the UTILITY MENU button and rotate the SELECT control until the display

will show:

ASSIGN PRESET

PRESS ENTER/CANCEL

2. Press the ENTER button. The display will show:

PRESET 0

A

UNASSIGNED

Advertising