Output gain – 360 Systems DigiCart/II Plus User Manual

Page 68

Advertising
background image

56

Operating Instructions

DigiCart/II Plus Owner's Manual

S

ETTING

F

ADE

O

UT

“O

N

T

HE

F

LY

To set the FADE OUT length while listening to audio:

1. Press PLAY. The cut will play back and the counter will count down.

2. Press STOP to set the beginning point of the FADE OUT.

3. The display will show the previous FADE OUT duration on the top line, and the

newly selected FADE OUT length on the bottom line:

4. Use Left and Right POSITION buttons to set the scroll value in brackets as

<H> = Hours, <M> = Minutes, <S> = Seconds, <F> = Frames or <B> = Bits.

5. Use the SELECT control to fine-tune FADE OUT length.

6. Press PLAY to audition the new FADE OUT.

DigiCart/II Plus will play the cut from the PRE-ROLL point to the TAIL point or
until you press STOP.

Repeat steps 4 and 5, as necessary.

7. Press the ENTER button to save changes, or CANCEL to exit.

S

ETTING

F

ADE

O

UT

W

HILE

S

TOPPED

To immediately set the FADE OUT length without hearing audio:

1. Press the STOP button. The display will show the current FADE OUT length on

both lines:

2. Use the Left and Right POSITION buttons to set the scroll value in brackets as

<H> = Hours, <M> = Minutes, <S> = Seconds, <F> = Frames or <B> = Bits.

3. Use the SELECT control to fine-tune the FADE OUT length.

4. Press the PLAY button to audition the new FADE OUT.

DigiCart/II Plus will play the cut from the PRE-ROLL point to the TAIL point or
until you press STOP.

Repeat steps 3 and 4, as necessary.

5. Press ENTER to save changes, or CANCEL to exit.

Output Gain

Allows the adjustment of the Output Gain (level) of a cut after it has been recorded. Gain may be
adjusted over a range of +6 dB to -90 dB, referenced to the initially recorded level.

Just as with all other Edit Menu functions, this function is non-destructive and the gain setting is
stored as part of a cut's header. DigiCart/II Plus will read the header to configure itself for
playback.

1. Press the STOP or PLAY button. The display will show the current gain setting

for the cut relative to the originally recorded level:

2. Use the Left and Right POSITION buttons to set the scroll value for decibels

(<1.0>) or tenths of decibels (<0.1>).

3. Use the SELECT control to adjust Output Gain.

4. Press the ENTER button to save changes or CANCEL to exit.

Advertising