Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 58)

HI-3010 Filler/Dispenser/IBC 42
Service Manual
effects of vibratory forces present in all industrial weight
control and measurement applications. By eliminating the
factor of vibratory forces the Filler/Dispenser is capable of
identifying the actual weight data. WAVERSAVER
®
enables
the Filler/Dispenser to distinguish between actual weight
data and mechanical noise, both of which are typically trans-
ferred to the Filler/Dispenser by the load cell signal.
WAVERSAVER
®
can be configured to ignore noise with fre-
quencies as low as 0.25 Hz. One of four higher additional cut
off frequencies may be selected to provide a faster instru-
ment response time. The function is user selectable and can
be turned off.
PARAMETER:WAVERSAVER
®
RANGE: .25 HZ, .50 HZ, 1.0 HZ, 3.50 HZ, 7.50 HZ,
OFF
DEFAULT: 1.00 HZ
Step 1. Press the Down arrow button until the cursor is in
front of WAVERSAVER
®
. (See Fig. 4-86)
FIG. 4-86 SETUP MENU/WAVERSAVER
Step 2. Press the right or left arrow buttons to select the set-
ting or turn WAVERSAVER off.
Step 3. Press the Enter button to set the entry.
Set Clock Parameter
About Setting the Clock
You set the Hour, Minutes, Month, Day and Year parameters
here. The settings are important when printing out the fill/
dispense data. These settings are the time stamps for the
alarms and fills/dispenses. The Timezone setting is used to
date the e-mails that are sent from the instrument in Green-
wich Mean Time (GMT).
PARAMETER:HOURS
RANGE: hh (01-24)
DEFAULT: NONE
PARAMETER:MINUTES
RANGE: mm (01-60)
DEFAULT: NONE
PARAMETER:MONTH
RANGE: Jan. thru Dec.
DEFAULT: NONE
PARAMETER:DAY
RANGE: dd (01-31)
DEFAULT: NONE
PARAMETER:YEAR
RANGE: yyyy (2001, 2002, 2003)
DEFAULT: NONE
PARAMETER:TIMEZONE
RANGE: -12 TO +12
DEFAULT: -8
Step 1. Press the Down arrow button until the cursor is in
front of Set Clock. (See Fig. 4-87)
FIG. 4-87 SETUP MENU/SET CLOCK
Step 2. Press the Enter button. The Clock Setup Menu
appears with the cursor in front of Set Hours. (See
Fig. 4-88)
FIG. 4-88 CLOCK SETUP MENU/SET HOURS
Step 3. Press the right or left arrow buttons to change the
Hours setting.
Step 4. Press the Enter button to set the entry.
Step 5. Press the Down arrow button until the cursor is in
front of Set Minutes.
Step 6. Press the right or left arrow buttons to change the
Minutes setting.
Step 7. Press the Enter button to set the entry.
Step 8. Press the Down arrow button until the cursor is in
front of Set Month. (See Fig. 4-89)