Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 63)

47 CHAPTER 4
Configuration
Configuring Ingredients from the Browser
About Configuring Ingredients
You will notice that the Instrument # is displayed on the Web
page. You can configure from 1 - 12 Ingredients from the
Browser. Each ingredient can be given an Ingredient Name,
Set Tolerance (Discrete or Percent), Target Weight, and Pre-
act. You can also configure the Gate Time, Jog On Time and
several other parameters. All these settings insure that each
ingredient is exactly configured to deliver the exact amount
of material for your filling process. The parameter ranges are
the same when setting the instrument from the Front Panel.
Step 1. Click on Adjust Ingredient. The Configuration -
Adjust Ingredient Page appears. (See Fig. 4-99)
FIG. 4-99 CONFIGURATION - ADJUST
INGREDIENT WEB PAGE
Step 2. Click on the Ingredient Number pull down menu.
(See Fig. 4-100)
Step 3. Move the cursor over the Ingredient number you
want to adjust. When the cursor hovers above an
ingredient the ingredient is highlighted.
Step 4. With the cursor over the Ingredient number, click
on the selection.
Step 5. Click on the Edit Ingredient Button. The second
page of the Adjust Ingredient web pages appears.
(See Fig. 4-101)
FIG. 4-100 EDIT INGREDIENT PULL DOWN MENU
FIG. 4-101 CONFIGURATION - ADJUST
INGREDIENT
Step 6. Lets stop a moment and look at this page (See Fig.
4-101). You see the Instrument ID in the upper left
hand corner of the graphic. The “Hardy Filler” tells
us that the instrument is a filler. If it was a Dis-
penser it would say “Hardy Dispenser” or if it was
an IBC Dispenser it would say “Hardy IBC Dis-
penser”. The Browser gets this information from
each instrument. You also see two arrows towards
the bottom of the page. These are navigation
arrows. To go forward click on the right arrow. To
go back, click on the left arrow.
Step 7. You also see Ingredient Number: 7 which we
selected in the previous web page. You can con-
tinue with this ingredient number or you can change
to another ingredient by clicking on the pull down
menu and selecting another ingredient number.