Hardy HI 3010 Filler/Dispenser Controller - Manual (Page 82)

HI-3010 Filler/Dispenser/IBC 66
Service Manual
FIG. 6-3 CONFIGURATION MAPPING SETUP 1/
SELECTING A DESTINATION
Step 3. Let’s take a moment to take a look at this page.
• Local Outputs include the 4 Output
Relays.
• Control includes parameters that control
the filling or dispensing which includes
the following which is only a partial list:
1. OK to Fill,
2. OK to Discharge
3. Start
4. Stop
• Instrument Setup include parameters for
setting up the instrument itself and
includes the following which is only a par-
tial list:
1. Auto Zero On
2. Tare Value
3. Zero Tolerance
4. Discharge On
• Ingredient Setup include parameters for
setting up the ingredients to fill or dis-
pense, and includes the following which is
only a partial list:
1. Max Weight.
2. Min Weight
3. Fill Time
4. Wait Time
• Network includes the network outputs for
Hardy Control Link, ControlNet, Devi-
ceNet, Profibus etc. which is only a partial
list.
1. Hardy Control-Link Text Out
2. Hardy Control-Link Int Out
3. DeviceNet Text Out
4. DeviceNet Int Out
• E-Mail includes E-Mail Outputs such as:
1. Send E-Mail
2. Custom Text
• Calibration includes calibration parame-
ters:
1. Zero Weight
2. Span Weight
• Scratchpad which are empty registers you
can do whatever you want with.
NOTE: The lists above do not include all the parameters.
For a list of all the parameters and their
addresses please see Appendix A.
Step 4. Back to our example. We want to select Output
Relay #1 as our destination. Click on the Local Out-
puts pull down menu. (See Fig. 6-4)
Step 5. Click on Output Relay. After you click on Output
Relay it is selected and a Number and a Select but-
ton appear to the right of the Local Outputs pull
down menu. (See Fig. 6-4)
Step 6. To select Output Relays from 1 - 4, double click in
the text box and type in the Output Relay number
you want. In our example we selected Output Relay
#1. (See Fig. 6-4)
FIG. 6-4 LOCAL OUTPUT/SELECTING OUTPUT
RELAY #1
Step 7. Click on the Select button to the right of the Relay
#1 text box. An address appears in the Current
Mappings text box below. You will have to scroll