To remove and replace foot, Changing the needle, Attaching blindstitch – SINGER 8234 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CHANGING PRESSER FEET
Snap-on Presser Feet
The presser feet furnished with your machine
snap on and off a common shank.
Raise needle to highest position by turning the
hand wheel toward you. Raise presser foot.
To Remove and Replace Foot
1 a. Press toe of presser foot upward as far as
it will go.
1 b. Then snap down to remove.
Centre the new presser foot under the
shank A and lower the presser foot lifter so
that the shank fits the presser foot pin.
Press presser foot screw down firmly until
foot snaps into place.
CHANGING THE NEEDLE
• Raise needle to its highest point by turning
the hand wheel toward you. Loosen needle
clamp screw B and remove the needle.
• Insert new needle up into clamp C as far as
it will go. with the flat side of the needle to
• Tighten needle clamp screw.
® Raise presser foot, loosen presser foot
screw with a coin and slip blindstitch hem
guide between screw and shank of the gen
eral purpose foot.
• Be sure underside of the guide clears the
slide plate and front of foot.
® Tighten screw with a coin.