Applications with straight stitching, Darning, With embroidery hoop – SINGER 8234 User Manual

Page 37

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Applications with straight stitching


With Embroidery Hoop

® Needle Position:

L . : 1 > : A


Stitch Width:

® Stitch Length:



Needle Plate Raising Shim (with model 8134)

® Snap-in Feed Cover (with model 8234)


No Presser Foot or Presser Foot Shank


Presser Bar: Lowered

® Insert needle plate raising shim as instruct­

ed on page 11 (Snap-in Feed Cover with
8234 Model).

m Trim ragged edges from area to be darned

and centre worn section in embroidery hoop

designed for machine use.

® Position hoop under the needle and lower

presser bar to engage tension. Hold needle

thread loosely with left hand, turn hand
wheel over and draw bobbin thread up
through fabric. Hold both thread ends and

lower needle into fabric. Take a few stitches

to secure.

Snip off thread ends close to fabric.

m Outline area to be darned with straight

stitches for reinforcement.

@ Stitch across opening, moving hoop under

needle at a slight angle from lower left to
upper right. Keep lines of stitching closely
spaced and even in length. When opening is

filled, cover area with crosswise lines of


This method of controlling fabric movement
with an embroidery hoop may be used to do
embroidering or monogramming.


This manual is related to the following products: