AMETEK XG Family Programmable DC User Manual
Page 251
Advertising
Communications Options
M370430-01 Rev E
6-45
6
To communicate with the power supply, use the program, National
Instruments Measurement and Automation Explorer (NI MAX).
You Can download the program from
http://www.ni.com
.
Important:
This section uses the National Instruments™ MAX program to
communicate with the XG. This is for demonstration purposes only. Any
software that is capable of addressing a serial device and sending and receiving
text could be used in its place.
Boot up NI MAX and click the Serial & Parallel section. You
should be able to see the port # from which you referenced the
Device Manager earlier. Verify the settings are the same as above
and click Open VISA Test Panel.
Advertising
This manual is related to the following products: