AMETEK XG Family Programmable DC - Manual (Page 259)

Communications Options
M370430-01 Rev E 6-53
6
SYSTEM COMMANDS
The system commands control the system-level functions of the
power source.
Subsystem Syntax
SYSTem
:COMMunicate
:LAN
:ADDRess Set LAN IP address
:APPLy Apply the change in setting
:CLASs Set LAN Host bits
:DEFault Set LAN to a default known setting
:DESCription Set user description
:DNSaddress Set LAN DNS address
:GWADdress Set LAN Gateway
:PASSword Set LAN password
:PORT Set LAN socket port address
:MACAddress Read the MAC address
SYSTem:COMMunicate:LAN:ADDRess
This command will set the LAN IP address. The query format returns the IP address
set. To query the actual IP address used by the LAN interface (in case the IP address
is not static but assigned by a DHCP server), the NCON parameter (Network
Connection Setting) must be added to the query. The default value is 0.0.0.0.
Command Syntax SYSTem:COMMunicate:LAN:ADDRess <NRF>
Parameters ddd.ddd.ddd.ddd <IP address>
Example SYST:COMM:LAN:ADDR 255.255.167.2
Query Syntax SYST:COMM:LAN:ADDR?
SYST:COMM:LAN:ADDR? NCON
Returned Parameters <CRD>
SYSTem:COMMunicate:LAN:APPLy
This command will apply the changes in LAN setting. The controller will go to reset
condition and the new LAN setting will take effect.
Command Syntax SYSTem:COMMunicate:LAN:APPLy
Parameters none
Example SYST:COMM:LAN:APPL
Query Syntax no query for this command
Returned Parameters none
SYSTem:COMMunicate:LAN:CLASs
This command will set the number of host address bits or a class. The query format
returns the number of bits set. To query the actual number of bits used by the LAN
interface (in case the IP address is not static but assigned by a DHCP server), the
NCON parameter (Network Connection Setting) must be added to the query. The