ARRIS TG1672G-NA Web GUI User Guide - Manual (Page 17)

Section 1: Configuring Your Router and Your Wireless LAN Connection
November 2013 Page 17 of 96
2.5 Setting Up Your WAN Connection
A Dynamic or DHCP (Dynamic Host Configuration Protocol) connection is the most commonly
used WAN connection type.
Note: Do not change this setting unless your Internet Service Provider tells you to use
another connection type.
Perform the following steps to change your connection type.
1. Access and log into the configuration interface.
2. Click the WAN Setup tab.
3. Click Dynamic, Dynamic (IPV6), Static, or Static (IPV6) in the side menu to display the
appropriate screen for configuring that type of WAN connection.
4. Set the required configuration parameters for the connection type you selected as provided
by your Internet Service Provider.
Note: Refer to WAN Setup in Section 2 - Web GUI Screens and Configuration
Parameter Reference for specific instructions on setting the various connection type
configuration parameters.
5. Click the Apply button at the bottom of the screen.