Digi MIL-3000FTX - Manual (Page 106)

MIL-3000FTX Series of FastPort Print Servers 10-7
--> Preferred DS Context : Sets the “context” where FastPort’s server/
queues are defined. The name entered must be a valid “Tree” or “Context.
The field is blank by default.
• Print Server Config .--> Queue Scan Rate : Sets the rate (times per second) that
FastPort scans the Novell queue for print jobs (valid numbers are between 1-
6). Default:
1 .
--> Frame Type : Selects NetWare’s frame type. Default: Autosensing .
--> Configuration Server : Is the server where FastPort’s bindery
configuration file resides. The field blank by default.
-->
Notification : Enabling this parameter allows FastPort to send status to
users on the Notify list Default: Disabled .
10.4.3General Config.
There are a series of choices that can be selected to configure FastPort for a
general network, including:
• Community Strings : Sets SNMP community strings . Default for “Get Community
String” is public . Default for “Set Community String” is private .
• Flash Config. --> Allow download : Allow/disallow the upgrade of the Firmware. Default:
Allow .
10.4.4Ethertalk Config.
There are a series of choices that can be select to configure FastPort for a
Ethertalk network, including:
Figure 10-11. Ethertalk Config. Selections
From Ethertalk Config., selections include:
• General Config .--> Zone Name : Logical group where FastPort exists.
--> Enable Ethertalk : Enables/disables the Ethertalk protocol. Default:
Disabled .
--> Ethertalk Phase : Sets the compatibility level of the Appletalk network
system. Default: Phase 2 .
• Parallel Printer Setup --> Printer 1 : This selection sets printer 1 port’s parameters.
--> Printer 2 (optional): Sets printer 2 port’s parameters.
--> Printer 3 (optional): Sets printer 3 port’s parameters.
Note: The number of printers to configure depends on the number of parallel ports on the
FastPort.