Digi MIL-3000FTX - Manual (Page 96)

MIL-3000FTX Series of FastPort Print Servers 9-9
• Show Node Name : When this option is selected, the software displays
host names for all the devices discovered. Checked by default.
• Show Node Address : When this parameter is chosen, FastManage
displays IP and IPX addresses for all the devices discovered. Not
checked by default.
• Load Saved Maps : When this option is selected, FastManage loads a
saved Map when starting the Discovery Application. Checked by
default.
• Save Maps On Exit : When selected, this option saves the Map when
Discovery is exited. Checked by default.
• Save Parameters On Exit : This selection saves the options when
the Discovery is exit. Checked by default.
• Refresh every : When chosen, this option refreshes the Map every
<n> seconds. Default is 60 seconds.
• Discover : When this parameter is selected, the software re-discovers
hosts every <n> seconds. Default is 90 secs .
• Dead : This parameter signifies the number of attempts FastManage
tried before marking the node as “dead” (off-line). Default is 2 unicasts.
• Wait : The selection denotes the amount of time the software waits for a
reply from a node. Default is 1 second.
• Default Map : This parameter selects the name of the default Map file:
map.map .
• Map File : This parameter enters the path for the Map file. Default is
C:/fm .
• Hosts File : This parameter enters the path for the hosts file. Default
is C:/ETC .
• Bootptab File : This selection enters the path for the bootptab file.
Default is C:/FM .
• Allow To Edit “Hosts” File : When this parameter is selected, the
software updates the “hosts” file if a new host is discovered. Checked
by default.
• Default : Initialize all the parameters to default values.
• Save Options : Saves all changes to the issnmp.ini file.
• Cancel : Cancels the changes.