Digi MIL-3000FTX - Manual (Page 69)

MIL-3000FTX Series of FastPort Print Servers 6-5
6.4.1.3Using Setup Font List
FastPort can be told the fonts available for printers connected to the
parallel port. If the printer fonts do not match the defaults, download a
modified Font List file to the FastPort.
1. Locate the Setup Font List file in the “Advanced Utilities” or “FastPort
Utilities” folder.
2. Double-click on the Setup Font List icon.
3. Edit the list of fonts to match your printer’s.
4. Save the list and quit “TeachText.”
5. Open the LaserWriter Utility .
6. Select Download PostScript File from “Utilities.”
7. Select the file Setup Font List . When the file completes
downloading, quit the utility.
The font list remains in FastPort’s memory until it restarted.
Note: The font list for the serial port of FastPort does not need to be changed.
Serial Port Parameters
Type (No Binary) or Binary
adobe or Binary hp Serial type is based on the traffic type and whether or not the port is
handling Binary PostScript.
Stop bits (1) or 2 Number of stop bits required.
Speed 300,600,1200,4800,(9600),
19200, 38400 Transmission speed (in bps).
Parity Yes or (No) Use of parity bit checking.
Xon (Yes) or No Use of Xon/Xoff for flow control.
Network Protocols Enabled
Sockets (Yes) or No
LPD (Yes) or No
NetWare (Yes) or No
EtherTalk (Yes) or No
Operational Parameters
Reset the Print
Server Yes or (No) Forces the print server to reboot when FastPort is power cycled.
Set IP address Set IP Address (0.0.0.0) Use to specify an IP address for FastPort using dotted-decimal format.
Reset NVRAM
to defaults Yes or (No) Forces NVRAM values to be returned to their defaults when FastPort is
power cycled.
Parallel Port Parameters
Enable Bi-direct.
Interface Yes or (No) Enables bi-directional printing (see chapter 11)
Table 6-5: Option (Default is in Parenthesis)
Option Choice Description