Digi MIL-3000FTX - Manual (Page 28)

MIL-3000FTX Series of FastPort Print Servers 3-3
6. Double-click on its displayed port (service) where the printer is
connected. A “ Select Driver ” dialog appears.
7. Choose a name for the printer.
8. Choose the driver for the printer that is connected to the FastPort port.
The “ Printer Setup ” dialog box displays.
9. Change any of the desired printer-specific settings.
10. Choose OK .
Windows NT systems is now configured to print to FastPort.
3.1.4 Printing from Windows 95/98 or Windows NT 4.x (via SMB)
Note: This installation requires FastPort firmware 6.1 or higher.
1. Open Network Neighborhood .
2. Choose the workgroup where FastPort is located.
3. Double-click on FastPort . FastPort appears as FPXXXXXX ; where
XXXXXX is the last six digits of the MAC address.
Figure 3-1. FastPort Menu Select
4. Double-click the port where the print job will go.
5. The “Do you want to create a printer on your local machine that prints
to this device” dialog box appears. Click Yes on this dialog box.
6. When prompted, select the driver for the printer connected to the
specific printer port.