Digi MIL-3000FTX - Manual (Page 81)

MIL-3000FTX Series of FastPort Print Servers 8-2
8.1.3 IP Configuration
1. Load Packet or ODI drivers for the NIC card
2. Add the following line to the net.cfg file for ODI Drivers:
Frame Ethernet_II
8.1.4 IPX Configuration
• Novell 4.1 Drivers for Windows and DOS. Refer to the Novell Netware
Documentation for information
• ODI Driver for the network interface card loaded
8.1.5 NetBIOS Configuration
NetBIOS over NetBEUI network configuration for Win 3.11 and/or Win 95.
8.2 Installing FastManage
There are two different modes of installation:
• Express installation
• Custom installation
8.2.1 Express Installation
Express install is the fastest way of setting up the FastManage software and
is recommended for first time users. For detailed installation, go to
“Custom Installation” on page 8-3. Do the following to install FastManage:
1. From “Start” (or “File”), select Run .
2. Type d:setup.exe (or the drive where the CD-ROM is located) on the
command line and click OK .
3. Register FastManage and click Next .
4. Confirm that the registration is correct and click Yes .
5. Choose the type of installation. In this case, select Express Install
(for first-time installation) and click Next .
Note: Go to Section 8.2.2 for Custom Installation (or Advanced) instructions.
6. Choose a network protocol: IP, IPX, or NetBIOS
Note: IPX requires Novell 4.1 DOS and Windows drivers already installed on the system.