Digi MIL-3000FTX - Manual (Page 121)

MIL-3000FTX Series of FastPort Print Servers C-5
5. Use an ASCII editor to prepare the following config. file:
SIMBA:QUEUEP:PS1:Parallel1::ss=”M-%-12345X@PJL enter
language = PostScript \r\n”,es=”M-%-12345X@PJL enter
language = pcl \r\n”,b=ps,cd
Or use the ACT menus:
1. Select the Advanced Configuration form the “Configure” menu.
2. Select Netware Configuration and Configure Queue .
3. Scroll down the list of printers and select one.
4. Scroll down the list of file servers and select one.
5. Scroll down the list of Queues and select one .
6. From the Queue Options menu, select Startstrings . The start string:
<Esc>%-12345X@PJL enter language = PostScript.
7. Add the end string <Esc>%-12345X@PJL enter language = pcl
to change the mode back to PCL.
8. To complete the configuration, select Send Control+D and select
PostScript from the choice Banner page.
C.2.1.5Example 2
The second queue on server SOAVE has a configuration file that puts an
HP LaserJet into PCL mode, sends the file without the banner (
b=off ), and
puts the printer back into PS mode. In plain text form that looks like this:
SOAVE:QUEUEP:PS:Parallel1:ss=”M-%-12345X@PJL enter
language = pcl\r\n”,es=”M-%-12345X@PJL enter language
= PostScript \r\n”,b=off
Configuration has info. about devices connected to FastPort.
C.2.2 Print Server Configuration
The Print Server Configuration menu allows a user to view print server
information, including network name, model number, and ROM version
(refer to Table C-1). Parameters that can be changed, including:
• Assign IP addresses for both FastPort and hosts that print to FastPort
• Set serial and parallel port parameters