Digi MIL-3000FTX - Manual (Page 48)

MIL-3000FTX Series of FastPort Print Servers 5-2
5.3 Digi Installation Software
1. Log in as root onto the system.
2. Create a directory to load the software (e.g., type mkdir Digi and
press [Enter]) and enter that new directory.
3. Load the software from the disk and type:
tar -xvf /dev/ <device>
where <device> is the name of the drive (usually FD0 ).
4. Type ls to list the files. The following information appears:
README.FIRST
unpack.sh
dist.tar.Z
licence.txt
5. Type ./unpack.sh to launch the install script.
5.3.1 Installing Logical Printers
Logical printers can be created with characteristics that print to the same
printer. To install a second printer:
1. Run the install.sh .
2. At the “Installation Options” menu, choose Option #2 .
3. Specify a second printer and answer the prompts as before.
5.3.2 Installing on System V UNIX
The install.sh creates a dummy device, adds a printer, and starts the
“lpsched” process. To install System V:
1. Run the install.sh .
2. Choose FastPort by its model number.
3. Choose Option #3, lpsched-based systems .
4. Select Option #1, Configure New FastPort to assign an IP
address. If an IP address was assigned, go to step 5. The script prompts:
– Host naming method (usually the /etc/hosts file)
– Exact type of system