Digi MIL-3000FTX - Manual (Page 85)

MIL-3000FTX Series of FastPort Print Servers 8-6
Figure 8-4. Discovery Parameters
• Use DNS : When checked and the IP/NetBIOS protocols are all
enabled, FastManage may be unable to resolve a NetBIOS name (e.g.,
SNMPA0702CA ). Turn this parameter “Off” if this is the case. The
“Enable IP” parameter must be selected to enable this option. Not
checked by default.
• Poll IP Range : When this option is selected, the software “polls” all
254 hosts of the subnet (from X.Y.Z.1 to X.Y.Z.254 ). The “Enable IP”
parameter must be selected to enable this option. Checked by default.
• Do IP Broadcast : If this parameter is selected, the software will
performs discovery through SNMP over IP broadcast. The “Enable IP”
parameter must be selected to enable this option. Checked by default.
• Every : If this parameter is selected, the software broadcasts every <n>
seconds to discover new devices. The “Enable IP” parameter must be
selected to enable this option. Not checked and
120 seconds by default.
• Times : This option is the number of times the system will “broadcast”
before giving up discovery of a node. The “Enable IP” parameter must
be selected to enable this option. Checked and
3 times by default.
• Poll “hosts” List : If this is selected, the software reads through the
list, if a name is in the hosts file, the software then uses SNMP to
discover each host. Checked by default.
• Poll Map List : If selected, the software “discovers” each host in Map
1 through SNMP. Checked by default.
• Find Only Digi Devices : If this checked, Discovery finds/displays
only Digi devices. Not checked by default.