Digi MIL-3000FTX - Manual (Page 25)

MIL-3000FTX Series of FastPort Print Servers 2-10
8. At the next prompt, type in the IP address as such:
Enter new IP address: 204.23.13.4
9. At the next prompt, press [R] to reset the system.
The nbmon session closes, while FastPort reboots itself. When the system
comes back up, the LEDs blinks steady (1 second manner). This indicates
that FastPort now has an IP address set.
2.11 Verifying IP Address is Set Properly
To see if FastPort is up and running on the network, use the ping
command, type:
ping < hostname> . A message that the host is alive
appears. If there is a problem, try using ping with the IP address:
ping < ip-address>
On some systems, the ping command continuously displays:
64 bytes from < hostname> (192.115.2.1) icmp_seq=0 time=3ms
To discontinue ping, press the Del key or Control+C