Digi MIL-3000FTX - Manual (Page 61)

MIL-3000FTX Series of FastPort Print Servers 5-15
For a parallel printer which will be used by PC-NFS:
parallel
hostname alpha
7. Start the printer and queue by typing the following:
lpc start beta
8. You can now print files with the lpr, or lp command.
lpr -Pbeta <filename> , or
lp -dbeta <filename>
5.5.5.1Printing to FastPort
After installing both hardware and software, FastPort is ready to print.
Commonly used BSD print commands include:
Note: * These parameters require root access.
5.5.5.2Customizing BSD Installation
Create the .fpconfig file in the spool directory (i.e., :sd= entry in
printcap ), since this is where daemon executes fpfilter. The .fpconfig file
should be owned by the daemon.
5.5.5.2.1Banner Pages and Accounting Information
To print a banner page, the install script must be told to print a banner. It
adds the command
bannerfirst to the . fpconfig file. To configure an
existing printer to send a banner, remove the existing printer and run the
installation script again.
Note: The banner-generating programs are supplied “as is.”
To print accounting info., add the line acctg to the . fpconfig file. This
causes accounting information to be written to the file specified
by
:af=< filename> in the printcap entry.
Table 5-4: BSD Print Commands
Command Function
lpr -p <printer> <file> Prints the file to the printer
lpq -P <printer> Displays any active queues for the printer
lpc stat <printer> Interactive program for printer management
lpc clean <printer> *Remove all print jobs for the printer
lpc restart <printer> *Restart this <printer> queue
lprm -p <printer> <job# > *Removes the <job# > from the print queue