Digi MIL-3000FTX - Manual (Page 143)

MIL-3000FTX Series of FastPort Print Servers G-1
A p p e n d i x G
Telnet, NBMON and Serial Connection Diagnostic
Console Options
G.1 Diagnostic and Configuration Commands: Commands
• C—Configure console (for status monitoring)
• D—Display summary configuration parameters
• E—Display/set ethernet options
• F—Flash firmware load enable/disable
• H—Displays help menu
• I—Display/set IP Address
• L—Limit monitor Network access by password
• N—Network Protocols menu
• P—Display/set parallel port parms and status
• R—Reset the FastPort
• S—Display/set serial port parms
• Z—Reset nvram to factory defaults
• *—Print ASCII test page
• +—Print Postscript test page
G.2 C—Configure Console (for status monitoring)
Console options:
1.(Off)
2.(Serial/Network)
3.(Network only)
4.(Last parallel port)
<enter> (don't change/continue)