Beisler 1282-4 - Manual (Page 22)

- 13 -
Closing Seam Machine 1282-4 Working Instructions Beisler Automated Sewing Equipment
Fig. 12/13
Fig. 12
Fig. 13
2. Change seam number of desired seam in direct
access.
Move cursor to seam number:
• Press
1
or
0
key.
Fig. 13: Display for seam number selection:
1 Passive seam number
3 Active seam number
B.3
Operation
B.3.3 Selecting the sewing program
After the machine has been turned on and the control pro-
gram has been activated, the sewing program that had
been selected last is set.
Sewing programs
1 are stored in the memory (M). The
program control memory can store up to 20 sewing pro-
grams (M 01-M 20).
Fig. 12: Up to two seams with corresponding seam num-
bers
2 and 3 are assigned to each sewing pro-
gram 1 . The two seams differ in their control functions
(see Section D, Programming Instructions) and can be
sewn either in automatic or manual change.
Depending on the production type of the sewing pieces,
various sewing programs for the program have been pre-
programmed at the factory.
Programs for trousers production:
M 01 Side seam with braid pocket
M 02 Side seam with pocket in side seam
M 03 Side seam with wing pocket
M 04 Crotch seam
M 05 Side seam with pocket in side seam
M 06 Side seam with seam interruption before hem (avai-
lable only for systems with additional thread cutter
feature)
Programs for jacket production:
M 01 Main seam
M 02 Seam interruption by stitch counter
M 03 Seam interruption by photocell
M 04 Thread cutting at beginning of seam, sewing start
in sewing piece
The seams of a sewing program can be sewn either in
automatic or manual change.
1. Select sewing program at operating panel.
The sewing programs M01- M09 can be selected di-
rectly by entering the seam numbers at the numeric
keypad. The sewing programs M10- M20 are selected
from the memory:
• Press  key.
Select sewing program number, e.g. 11:
• Press and keys.
Confirm selection:
• Press & key.