Beisler 1282-4 - Manual (Page 72)

- 16 -
Closing Seam Machine 1282-4 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
44 SIDE GUIDE AT THE FOOT
Sewing section after which the stop changes the position at the pressu-
re foot (away from the pressure foot)
For setting 000 cm, the position at the pressure foot is already wide
when sewing starts
45 GUIDE ON FOOT INTERVAL
Sewing section after which the stop changes the position at the pressu-
re foot (toward the pressure foot)
For setting 000 cm and a setting of 001 cm for parameter 44, the positi-
on at the pressure foot is already narrow when sewing starts (positio-
ned at the pressure foot)
]
Seam break
33 MODUS FOR BREAK
00 without seam break
01 with seam break; programmed sewing section from beginning of
seam to seam break; seam opening by rolling with puller
02 with seam break; photocell detects cloth edge; compensation stit-
ches until seam break is determined by parameter 34; seam ope-
ning by rolling with puller
05 with seam break; programmed sewing section from beginning of
seam to seam break; seam opening by rolling with puller and rol-
ler unit
06 with seam break; photocell detects cloth edge; compensation stit-
ches until seam break is determined by parameter 34; seam ope-
ning by rolling with puller and roller unit
09 with seam break; programmed sewing section from beginning of
seam to seam break; seam opening by pulling with cylinder 25
10 with seam break; photocell detects cloth edge; compensation stit-
ches until seam break is determined by parameter 34; seam ope-
ning by pulling with cylinder 25
34 DISTANCE TO BREAK
Programmable sewing section, depending on mode, from beginning
of seam or from detection by photocell
35 BREAK LENGTH
Programmable sewing section of seam opening by puller or by puller
and roller unit
29 ROLLER SPEED
Roller speed for seam break with puller or with puller and roller unit;
max. 99 %
20 MODUS CONDENSED STITCH
Changing the stitch length to backstitch the seam
00 Off
01 On