Beisler 1282-4 - Manual (Page 49)

Closing Seam Machine 1282-4 Working Instructions
- 20 -
Beisler Automated Sewing Equipment
C.5
Maintenance
Setting the automatic rule stop with catch:
1. Fig. 16: Remove two fixing screws
2 to set rule stop.
2. Set maximum/minimum stitch width and tighten fixing
screws.
2. To set distance A (between pressure head 5 and line-
up surface at stop 1 ), rotate knurled screw 4 . Di-
stance A should be 0.1-0.2 mm.
3. Check distance using feeler gauge, then tighten lok-
king lever to secure correct distance.
4. Set sewing start position to 001 mm (note original value
as it is required in Step 8).
Set lateral start position of contour guide (direct access
with F7) in a way that ensures that the rule stop edge
and the stop pins in the contour guide are lined up with
the front position of the rule stop (OUT 19).
Adjust catch shaft extension
4 (OUT 27) (see Sec-
tion D.4.2, Programming instructions). Set lateral stop
position to value of start position.
5. Loosen catch fixing screws 6 and push catch up to
the catch shaft 4 .
6. Tighten fixing screws.
7. Move rule stop to rear position (OUT 19). Carefully re-
duce lateral start position until distance between catch
5 and catch shaft 4 is approx 0.1 mm.
8. Set start position to original value.
Fig. 16
Fig. 16