Beisler 1282-4 - Manual (Page 50)

- 21 -
Closing Seam Machine 1282-4 Working Instructions Beisler Automated Sewing Equipment
C.5
Maintenance
C.5.5 Machine set-up
Adjusting the seam control photocell:
Fig. 17: The seam control photocell
1 controls the start
and the end of the sewing process. The red light beam 5
of the photocell should be positioned centrally on the re-
flective film
4 at distance A of approx 1.0-1.5 mm in front
of the needle 6 .
1. To position the light spot centrally on the reflective film,
loosen mounting bar fixing screw 3 and move bar into
desired position. Tighten fixing screw.
2. To position the light spot at the correct distance to the
needle, loosen photocell mounting fixing screw 2 and
shift mounting on mounting bar, then tighten fixing
screw.
Fig. 17
Fig. 17