Comtech EF Data MBT-5003 - Manual (Page 13)

MBT-5003 L-Band Up/Down Converter System Revision 1
Preface MN-MBT5003
xi
EN55082-1 – 1997 Compliance
This equipment meets the EMC/generic immunity standard as defined per EN55082-1 1997.
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instruction manual, it may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference; in which case,
users are required to correct the interference at their own expense.
NOTE
To ensure compliance, properly shielded cables for DATA I/O shall be used. More
specifically, these cables shall be shielded from end to end, ensuring a
continuous shield.
Safety Compliance
EN60950
Applicable testing is routinely performed as a condition of manufacturing on all units to ensure
compliance with safety requirements of EN60950. This equipment meets the Safety of Information
Technology Equipment specification as defined in EN60950.
Low Voltage Directive (LVD)
The following information is applicable for the European Low Voltage Directive (2006/95/EC):
<HAR> Type of power cord required for use in the European Community.
!
CAUTION: Double-pole/Neutral Fusing
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
International Symbols:
Symbol Definition Symbol Definition
Alternating Current Protective Earth / Safety Ground
Fuse Chassis Ground
NOTE
For additional symbols, refer to Cautions and Warnings listed earlier in this Preface.