Comtech EF Data MBT-5003 - Manual (Page 6)

MBT-5003 L-Band Up/Down Converter System Revision 1
Table of Contents MN-MBT5003
iv
1.4.1 Physical & Environmental ........................................................................................................ 1–6
1.4.2 Prime Power ............................................................................................................................. 1–6
1.4.3 Monitor & Control .................................................................................................................... 1–6
1.4.4 Reference .................................................................................................................................. 1–6
1.4.5 BUC-5003 Block Up Converter (featured on MBT-5003-XUR) ............................................. 1–7
1.4.6 BDC-5003 Block Down Converter (featured on MBT-5003-XDR) ........................................ 1–8
1.5 Dimensional Envelope ................................................................................................................ 1–9
CHAPTER 2. INSTALLATION .............................................................................................. 2–1
2.1 Unpacking and Inspection .......................................................................................................... 2–1
2.2 Installation ................................................................................................................................... 2–2
2.2.1 Standard Rack Mount Installation ............................................................................................ 2–2
2.2.2 Installation Using Optional Bearingless Rack Slide Set ........................................................... 2–3
2.3 Connect External Cables ............................................................................................................ 2–4
CHAPTER 3. EXTERNAL CONNECTORS ........................................................................... 3–1
3.1 External Connectors Overview .................................................................................................. 3–1
3.2 MBT-5003 External Connectors ................................................................................................ 3–2
3.2.1 Front Panel Connectors .............................................................................................................. 3–2
3.2.1.1 REF OUT Connector, Type ‘BNC’ Female ...................................................................... 3–2
3.2.1.2 RF OUT Connector (MBT-5003-XUR only), Type ‘N’ Female ...................................... 3–2
3.2.1.3 RF IN Connector (MBT-5003-XDR only), Type ‘N’ Female .......................................... 3–3
3.2.2 Rear Panel Connectors (Typical MBT-5003-XUR / MBT-5003-XDR) .................................. 3–3
3.2.2.1 J1 | 5/10 MHz EXT REF IN Connector, Type ‘BNC’ Female ......................................... 3–3
3.2.2.2 J2 | IF Connector, Type ‘TNC’ Female............................................................................. 3–3
3.2.2.3 J3 | COM Connector (EIA-485 Interface), DB-9F ............................................................ 3–3
3.2.2.4 J4 | RELAY (Summary Fault Output) Connector, DB-9F ................................................ 3–4
3.2.2.5 J5 | 10/100 Ethernet (M&C 10/100 BaseT Ethernet) Port, (RJ-45) .................................. 3–4
3.2.2.6 POWER IN (IEC Line Input AC Power) Connector ........................................................ 3–5
3.2.2.7 Ground Connector ............................................................................................................. 3–5
CHAPTER 4. FLASH UPGRADING ...................................................................................... 4–1
4.1 Introduction ................................................................................................................................. 4–1
4.2 Ethernet FTP Upload Procedure ............................................................................................... 4–2
CHAPTER 5. FRONT PANEL OPERATION ......................................................................... 5–1
5.1 Introduction ................................................................................................................................. 5–1
5.1.1 Switch Power On ...................................................................................................................... 5–2
5.1.2 LED Indicators ......................................................................................................................... 5–2
5.1.3 Keypad ...................................................................................................................................... 5–3