Comtech EF Data MBT-5003 - Manual (Page 87)

MBT-5003 L-Band Up/Down Converter System Revision 1
Appendix A MN-MBT5003
A–11
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
(Note that all arguments are ASCII numeric codes
between 48 and 57)
Response to
Command
(Target to
controller)
Query
(Instruction
Code and
qualifier)
Response to query
(Target to controller)
IP Address IPA= 18 bytes Command or Query.
Used to set the IP address and network prefix for the 10/100
BaseT Ethernet management port, in the format
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Default Value: 192.168.001.004.24
Example: IPA=-192.168.001.004.24
IPA=
IPA?
IPA*
IPA# IPA? IPA= xx.xxx.xxx.xxx.yy
(See Description of
Arguments)
Gateway
Address IPG= 15 bytes Command or Query.
Used to set the Gateway IP address for the
10/100 Base Tx Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the IP address
Default Value: 192.168.001.005
Example: IPG=192.168.001.005
IPG=
IPG?
IPG * IPG? IPG = xxx.xxx.xxx.xxx
Initialize
Statistics
Pointer ISP= None Command only.
Resets internal pointer to allow RNS? Queries to start at the
beginning of the stored statistics log.
Example: ISP=
ISP=
ISP?
ISP* N/A N/A
Local/Remote
State LRS= 1 byte Command or Query.
Set Local or Remote
0 = Local, 1=Serial, 2=Ethernet\
Default value: 0
Example: LRS=1
Note: The customer will always have query access in either mode.
Also, the LRS command is available in all modes as a means of
acquiring control. The intent of this command is to limit changes
from being made on multiple interfaces at the same time.
LRS=
LRS? LRS? LRS=x
(Same format as command
arguments)
Unit MAC
Address N/A 17 bytes Query only.
MAC address of the unit, reported in hexadecimal.
Example: MAC=00-06-B0-00-D2-A7
MAC=
MAC* MAC? MAC=xx-xx-xx-xx-xx-xx
(See Description of
Arguments)