GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual User Manual
Page 116
Parameter Modification
PL1877A Microprocessor Radio Telephone Interconnect
12/10 110
Para-
meter
No.
Description
Control Digits
Refer to
Section on
Page:
139–144 Prefix to * attendant access code - the code
an attendant user enters as a prefix to the *
command before being granted direct
channel access or selective signaling
privileges.
Valid range = 0–$D
101
145–150 Landline remote parameter programming
code - when enabled, the code must be
entered as a prefix to one of the landline
programming commands.
Valid range = 0–9, A–D, FF
Default = disabled
90
163
Off-hook Voltage Threshold
See appropriate section.
88
165
Time between automatically answering a
land-line call and generating a beep
prompt (time = 500 ms + x)50 ms))
Valid range = 0–15
Default = 0
99
177–196 Auto-dial location #1.
See appropriate section.
98
197–216 Auto-dial location #2.
See appropriate section.
98
217–236 Auto-dial location #3.
See appropriate section.
98
237–256 Auto-dial location #4.
See appropriate section.
98
257–276 Auto-dial location #5.
See appropriate section.
98
277–296 Auto-dial location #6.
See appropriate section.
98
297–316 Auto-dial location #7.
See appropriate section.
98
317–336 Auto-dial location #8.
See appropriate section.
98
337–356 Auto-dial location #9.
See appropriate section.
98
357
Overall access time limit. Any number
greater than 59; sets the overall access
time limit to an infinite duration.
Valid range = 1-59 minutes
Default = 0
94
358
The number of 25-ms periods in the signal
search frequency.
Valid range = 10–100
83
359
The number of 5-ms periods in the signal
search sample duration.
Valid range = 3–20
83
360
The length of time before disconnect that
time out warning ticks are generated.
Valid range = 0–59 seconds
Default = 15
94
361
Determines the time between SID
transmissions. If this parameter is
programmed to 0, periodic SID is disabled.
Valid range = 0–59 minutes
95
362-367 Multi-digit access prefix #1.
Valid range = 0–9, A–D, FF
91
368-373 Multi-digit access prefix #2.
Valid range = 0–9, A–D, FF
91
374-379 Multi-digit access prefix #3.
Valid range = 0–9, A–D, FF
91
380-385 Multi-digit access prefix #4.
Valid range = 0–9, A–D, FF
91